Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2003, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 5 Feb 2003 15:38:32 -0800
Reply-To:     Tom Young <tomyoung1@ATTBI.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Young <tomyoung1@ATTBI.COM>
Subject:      Re: Need a torque value, please
Comments: To: Ben McCafferty <ben@volkscafe.com>
Content-Type: text/plain; charset="iso-8859-1"

Hi Ben:

No, these bolts come in from the back side of the Cooling fan with pulley and 19.2 doesn't show them.

Thanks! --------------------------------------------------------------- Tom Young '81 Vanagon Lafayette, CA 94549 '82 Westfalia --------------------------------------------------------------- ----- Original Message ----- From: "Ben McCafferty" <ben@volkscafe.com> To: "Tom Young" <tomyoung1@ATTBI.COM>; <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, February 05, 2003 2:10 PM Subject: Re: Need a torque value, please

> Hi Tom, > Not sure if it's what you seek, but page 19.2 in my manual shows "cooling > fan with pulley" and the bolts bet 15 ft lb/20 nm. They don't look like > tri-squares, though, more like typical hex bolts, and only three of them. > The allen bolts that hold the water pump pulley to the water pump take the > same torque, and I wonder if they aren't very similar? > tx, > bmc :) > Ben McCafferty > ben@volkscafe.com > > Volks Cafe > 1823 Soquel Avenue > Santa Cruz, CA 95062 > 831-426-1244 > http://volkscafe.com > > > > From: Tom Young <tomyoung1@ATTBI.COM> > > Reply-To: Tom Young <tomyoung1@ATTBI.COM> > > Date: Wed, 5 Feb 2003 13:23:00 -0800 > > To: vanagon@GERRY.VANAGON.COM > > Subject: Need a torque value, please > > > > Hi all: > > > > I've separated the large cooling fan from the pulley it's attached to in > > order to clean things up and paint the pulley. The van is attached to the > > pulley via 4 bolts with "triple-square" heads, similar to CV joint bolts. > > > > Does anybody know the proper assembly torque for these bolts? I can't seem > > to find it in Bentley. > > > > TIA. > > --------------------------------------------------------------- > > Tom Young '81 Vanagon > > Lafayette, CA 94549 '82 Westfalia > > --------------------------------------------------------------- >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.