Date:         Wed, 12 Feb 2003 19:34:04 -0600
Reply-To:     Stan Wilder <wilden1@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Re: VDO Oil Pressure Extension Adaptor
Comments: To: gull@CYBERSPACE.ORG
Content-Type: text/plain; charset=us-ascii

There are a couple of tricks to this.
#1) Use galvanized or steel 1/8" pipe for the nipples. Keep then about 2"
long. (brass is much more fragile)
#2) Use a 45 degree angle to get that clearance you need.
#3) A few trips into the brass fitting with the threads will knock down
the sharp edges and it will screw into the block with a better fit.
#4) Standard grease gun hoses are rated at 3000 psi, the $3.99 hoses I've
been getting are.

Stan Wilder


On Wed, 12 Feb 2003 20:03:01 -0500 David Brodbeck <gull@CYBERSPACE.ORG>
writes:
> On Wed, 12 Feb 2003, Ben McCafferty wrote:
>
> > Check out Bill Davidson's article on this at vanagon.com.  I used
> his
> > procedure with two exceptions:  make the hose 5" long, and notch
> the tin
> > instead of putting a hole in it--that way you can remove the tin
> without
> > removing the hose or sender.  You can have your own hose made for
> about 8-10
> > bucks, and it is a much better fit than the VDO version--far from
> exhaust,
> > etc.

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com