VANAGON archives -- February 2003, week 3 (#357)

Date: Tue, 18 Feb 2003 10:40:23 +0100 Reply-To: Per Martin Joraholmen <per_martin_j@HOTMAIL.COM> Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com> From: Per Martin Joraholmen <per_martin_j@HOTMAIL.COM> Subject: Slave cylinder bracket Content-Type: text/plain; charset="iso-8859-1"

I have posted this question on the "spare" list, but still haven't resolved my problem.

The problem is that I have lost almost all clutch functions. Looking at the slave cylinder when in operation, the bracket that holds the slave cylinder slides out on the sleeve around the clutch arm towards the arm it self (2-3mm), causing the bracket to move upwards about 3-5mm. All bolts are tighten and the brace is in place. Should there be something that holds the bracket in place around the sleeve of the clutch arm ?

btw... it is a -86 with a 2.0 l gas engine (used to be a 2.1 l fuel injection)

Thanks

Per Martin

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.