In a message dated 2/27/03 8:50:31 PM, SyncroWesty@ATTBI.COM writes: << Anyone have any idea? >> Cory, The toughest press fit which I have found on a Vanagon is probably the front wheel bearings of a Syncro. I don't have a quantity to specify for the ultimate amount of force which is needed but, I do know this: if the press has SnapOn on it, a 20 ton rating will work admirably, whereas, if the press is labeled Harbor Freight, 50 tons might be needed plus a rap with a beater to finally get the part to seat. In my experience, the deformation of the frame of a cheap press will cause the workpiece to become cocked with respect to the line of thrust and a lot of extra push is needed to overcome this shortcoming. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.