Raul, yes, that is the support for the one way inside the torque convertor. There is another one inside the trans. To put them together on the bench (or floor) carefully line them up and have one of you rotate the convertor slowly back and forth as one of you apply pressure, they will slip together very easy when every thing lines up. Make sure you remove the governor first. do not use the mounting studs to pull the two together until all four nuts will go on at the same time, at this point you will know every thing is lined up and can pull it in evenly tightening each nut a little at a time. Jeff E. Lilburn, Ga. 87'WESTY 87'GL |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.