Doesn't the Bosch O2 sensor use a coaxial cable, with a ground braid on the outside and the signal wire on the inside? When you spliced it, could you have inadvertently shorted the inner and outer conductors? Steve
At 08:45 AM 3/16/2003, you wrote: >Please explain this connection? > > >I used a 1 wire bosch unit same as what was on the van. just cut the >connector from old and put it on the new one.)< > >Howard |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.