Date:         Sun, 23 Mar 2003 09:13:42 -0600
Reply-To:     Stan Wilder <wilden1@JUNO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Re: lifters for new engine?
Comments: To: vgonman@MSN.COM
Content-Type: text/plain; charset=us-ascii

I've pulled down some Type IV engines with solid lifters.
Other than the different push rods and lifters I see the same cam wear,
dropped valve seats. I've seen both chrome molly and aluminum type push
rods. Got a few sets of lifters and push rods.
About the only thing I can definitely say I find out of the ordinary is
chips in the valve stems and pitted adjusting screws from neglect of
adjusting the solid lifters. (use valve stem caps)
In effect the hydraulic became solid when it is properly adjusted and you
have sufficient oil pressure.
Whatever way you go you will get about the same mileage out of your
engine as long as it is serviced properly.

Stan Wilder

On Sun, 23 Mar 2003 09:00:18 -0500 Vanagon man <vgonman@MSN.COM> writes:
> Mechanical, but you have to use a mechanical cam and pushrods along
> with the
> lifters.
>
> The hydraulics are not what they are cracked up to be.
>
> Go to www.theshoptalkforums.com
>
>

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com