Date:         Mon, 24 Mar 2003 00:47:05 -0500
Reply-To:     Steven Dodson <steven@EPOCHDESIGN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steven Dodson <steven@EPOCHDESIGN.COM>
Subject:      Re: Q: Size of forward Syncro tranny drain plug (fill hole)

Thanks everyone for your help!!

My low cost solution was to use a M10 x 40mm bolt with 3 nuts locked
together, fits in 17mm socket and allows you to apply pressure while
turning.


-Steven Dodson
Kneeland, CA
'Inga' the 87 Syncro

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.