Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Mar 2003 00:30:56 -0600
Reply-To:     mike boland <westy@MVBOLAND.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mike boland <westy@MVBOLAND.COM>
Subject:      Re: FS Air Cooled Parts and Full Engines
Comments: To: Stan Wilder <wilden1@JUNO.COM>
In-Reply-To:  <20030325.181424.836.2.wilden1@juno.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Stan... 99% of us here are water cooled... excpt me I got both..

At 06:14 PM 3/25/2003 -0600, Stan Wilder wrote: >Type IV air cooled engine parts, short blocks and full engines. >--------------- Number 1-------------------------- >1) CV or GE series Stock crank, standard, will polish to marginal std or >turn .010/.010 $50.00 >2) CV and other Stock crank, standard polished to standard $100.00 >3) GE Series Type IV Engine case with studs, standard align bore not >oversized 72-79 engine mounting $100.00 >4) CV Series Type IV Engine case with studs, .020 align bored, 80-83 >Vanagon, welded oil gallery plugs. $150.00 >5) CV Series Short block, 5K on mains. 5K Cylinders honed, new std rod >bearings, new std bore rings, new lifters, new cam, new Melling Oil Pump. >I'll ship this engine with cylinders, rings, new bearings installed or in >the boxes . $500.00 >6) CV Series Long Block Engine, 5K heads, 5K cylinders, 5K cam and >lifters new bearings throughout, crank std, rods std. Windage Tray, >Notched Rods, fully assembled. $1300.00 >7) CV Series Long Block engine, forged steel counted weighted crankshaft, >new pistons / cylinders, new cam, all new bearings, notched rods, all >pistons, rods, crank are balanced, windage tray, new heads have three cut >valve seats, oil galleries plugged with threaded plugs. Manifold vacuum >18 psi, oil pressure at 100c 2000 rpms, 56 psi, .010 end play setting >$2300.00 >All assembled long blocks have been bench run in at 2000 rpms for 20 >minutes and run in farther for two hours at 2000 rpms. No core charges on >these engines. > >Stan Wilder > >________________________________________________________________ >Sign Up for Juno Platinum Internet Access Today >Only $9.95 per month! >Visit www.juno.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.