Date: Sun, 23 Mar 2003 21:01:02 -0600
Reply-To: Stan Wilder <wilden1@JUNO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stan Wilder <wilden1@JUNO.COM>
Subject: Re: Lapping cylinders to heads?
Content-Type: text/plain; charset=us-ascii
Torque your heads down before you go lapping the cylinders. Check head to
piston outer edge clearance.
If you heads are new or recently fly cut there aren't any needed
corrections that lapping give you.
If you have minor flame cutting on the sealing surface have the heads fly
cut to remove the damage and make up the change with base shims or head
gaskets.
A few heat cycles on good heads will give proper seating unless the heads
are warped.
Most Air Cooled heads will have fuel sludge drips from the lower cylinder
area simply because the new fuels are very good solvents. These leaks are
common and seal almost immediately after the engine starts.
Stan Wilder
On Sun, 23 Mar 2003 18:47:16 -0800 Paul Archibald <androbus@YAHOO.COM>
writes:
> ???????no comprende!!!!!!!
> I've never heard of lapping the heads to cylinders.
> could you clarify? if it's needed on the type 4 engine I
> need to know before putting the heads back on when I am
> finished with the repairs to them...never done on the older
> engines...
>
> Paul
________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com
|
Back to: Top of message | Previous page | Main VANAGON page
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives
@ gerry.vanagon.com
The vanagon mailing list archives are copyright (c)
1994-2011, and may not be reproduced without the
express written permission of the list administrators.
Posting messages to this mailing list grants
a license to the mailing list administrators to reproduce
the message in a compilation, either printed or electronic.
All compilations will be not-for-profit, with any excess
proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively
towards the management and operation of the Vanagon mailing
list and vanagon mailing list web site.