Hello, Did engine swap and am puzzled.......Used same FI that motor had on it, and can turn it over, runs a few seconds then dies............used a noid light, and no pulse to injectors, but apparently cold start is firing. Car ran fine until engine seized..........thus replaced motor. No injector Pulse: * Checked and cleaned all grounds to FI harness. * Verified engine ground * Changed ECU with known good one * Changed ECU with another known good one * *Changed resistor pack (yellow bus) * Changed double relay with known good one * *Changed AFM with known good one Vehicle still starts and stalls. I couldn't verify FI Pulse after first time because I was alone but there was no change. I seem to remember this happenning on another car of mine a couple years ago and it was simple.but I can't remember what i am missing!
Adam P 81 Westy "The Brick " 70 Single Cab "Whitey" 74 Beetle "Ol Yeller" 73 Transporter (STILL at paint shop) 1988 Vanagon Wolfsburg 1976 Transporter (New CA bus) 1974 412 "Goldmember" Used Vanagon Parts for sale (mostly aircooled) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.