Date: Sun, 30 Mar 2003 06:53:28 -0500
Reply-To: Jon <jon@FOREIGNAUTOSUPPLY.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jon <jon@FOREIGNAUTOSUPPLY.COM>
Subject: Re: No injector pulse 81 AFC vanagon
Content-Type: text/plain; charset="iso-8859-1"
Adam,
You may have already tried these. But, I'll toss 'em out anyway... I've had
this happen a couple of times, and it's very frustrating because nothing was
touched other than engine swap. 1. Plug contacts (female pins) on AFM plug
may be pushed into plug. 2. Loose contact at hot side of coil will do it...
sometimes just wiggling the black lead will get the noid light to fire...
pointing towards corrosion in the connector.3. Terminal 88y is most common
at double relay plug ...pulling out of white connector going into double
relay,or backed out a little. 4. Corroded wire in power supply box (left
rear of engine compt) is rare but has happened 5. Depending on model you
have, you may have a bad electronic ignition control unit if you're model
is equipped with one. You didn't mention if fuel pump was firing so I
assume it was... so that pretty much leaves out solenoid wires being
swapped... on some after market starters that would make a
difference---Goodluck please let me know what you find---Jon
----- Original Message -----
From: "Vanagon man" <vgonman@MSN.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, March 30, 2003 7:43 PM
Subject: No injector pulse 81 AFC vanagon
> Hello,
>
> Did engine swap and am puzzled.......Used same FI that motor had on it,
and
> can turn it over, runs a few seconds then dies............used a noid
light,
> and no pulse to injectors, but apparently cold start is firing. Car ran
> fine until engine seized..........thus replaced motor.
>
> No injector Pulse:
>
> * Checked and cleaned all grounds to FI harness.
> * Verified engine ground
> * Changed ECU with known good one
> * Changed ECU with another known good one * *Changed resistor pack (yellow
> bus)
> * Changed double relay with known good one * *Changed AFM with known good
> one
>
> Vehicle still starts and stalls. I couldn't verify FI Pulse after first
time
> because I was alone but there was no change.
>
> I seem to remember this happenning on another car of mine a couple years
ago
> and it was simple.but I can't remember what i am missing!
>
>
>
> Adam P
> 81 Westy "The Brick "
> 70 Single Cab "Whitey"
> 74 Beetle "Ol Yeller"
> 73 Transporter (STILL at paint shop)
> 1988 Vanagon Wolfsburg
> 1976 Transporter (New CA bus)
> 1974 412 "Goldmember"
> Used Vanagon Parts for sale (mostly aircooled)
|