Date:         Wed, 2 Apr 2003 12:43:28 -0800
Reply-To:     Robert Keezer <warmerwagen@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Robert Keezer <warmerwagen@HOTMAIL.COM>
Subject:      Re: Replacing front shocks
Comments: To: mjstelk@HOTMAIL.COM
Content-Type: text/plain; format=flowed

Jack up front on level ground , put on jack stands. Remove tires.

I use two 22 mm sockets on 1/2" drive ratchets for to loosen the bottom
shock bolt.

The top nut is 17 mm and you may need a 5 mm hex or a adjustable wrench to
hold the rod from turning as you loosen the nut. Once all the bolts and nuts
are off, the shock drops out from below.

You save the spacers , the rubber donut and dish washer to go back on the
new shock in the order they came off the old.

Put the top nut on a few turns to hold the shock, then center the bottom
shock bushing and install the bolt.
Tighten all and make sure the top nut is snug.


Robert

1982 Westfalia



----Original Message Follows----
From: Marla Stelk <mjstelk@HOTMAIL.COM>
Reply-To: Marla Stelk <mjstelk@HOTMAIL.COM>
To: vanagon@GERRY.VANAGON.COM
Subject: Replacing front shocks
Date: Wed, 2 Apr 2003 14:15:11 -0500

Hi volks,

I'm about to replace the front shocks on my van and wanted to see if anyone
had any early advice they'd like to share with me as I've never done it
before.  Do I need a torque wrench to do this job?

Peace,
Marla
'87 Westy GL Van "Morrison"





_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?page=features/junkmail


Robert
1982 Westfalia 1987 Wolfsburg

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
http://join.msn.com/?page=features/featuredemail