Stan, I assumed you meant to say conductive, instead of nonconductive, since 3M makes a conductive silicone grease. Is there also a nonconductive version? (I know little about this stuff, but plan on getting some tomorrow if I can find it). I always figured it was better to have a conductive grease, as it can possibly lower the resistance at the connector by increasing the contact area. But this only applies to single conductor connectons of course. For multiple conductor connections as many of the FI ones are, nonconductive makes sense. In my case, I find any of the FI connectors with the spring release sealed boots (ie: the fuel injectors, AFM, temp sensors, etc) are *very* good at sealing out the elements. My van has an incredible amount of corrosion in the engine compartment in general (300k km of its life spent in Ontario), yet all of these connectors seem to have no corrosion when pulled apart. The exposed ground connections are a different story. I snapped the ground bolt to driver side body off a few years ago, and today the ground bolt to the driver side head broke off as I tried to remove it to clean the connections. I used the adjacent allan-head bolt holding a metal coolant line instead, for now. I'm going to get some heavy gauge cable tomorrow & try to establish a solid ground from the alterntor to the body on the other side, so this ground should be less critcal. On 12 Apr 2003 at 21:17, Stan Wilder wrote: > What did I not say?. > We don't want to conduct electricity. > We want to seal the FI wiring plug-ins against moisture. > Hopefully if they are sealed against moisture and dirt it will be less > corrosive. > > Stan Wilder > > On Sat, 12 Apr 2003 18:48:01 -0700 Shawn Wright <swright@ZUIKO.SLS.BC.CA> > writes: > > I assume you mean conductive...? > > > > On 12 Apr 2003 at 18:10, Stan Wilder wrote: > > > > > Clean them very good then pack them with nonconductive silicone > > grease. Shawn Wright, I.T. Manager Shawnigan Lake School swright@SLS.bc.ca http://Zuiko.sls.bc.ca/swright http://www.sls.bc.ca |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.