Bob, Ifact they do pull off. Be very careful not to break them. Grab them not by the knob but the inner part of the lever. They will come off. Eric 86-VW4x4 vw4x4@fyi.net 86-SS Syncro Pittsburgh, PA USA 1936-Chrysler 92-Jetta GWC www.fyi.net/~vw4x4/vw4x4.htm On Sat, 19 Apr 2003, Bob Stevens wrote: > I was just in that part of the dash. Pried off the plastic plate to replace > the heater fan switch. Noticed the plate could not be taken off as the knobs > on the sliding heater/fresh-air/directional levers, are part of the sliders > and do not pull off. Is the access thru the ash tray? Or pull off the > plastic panel below the dash, in fron of the shifter? > > Bob > > > > Bob, > > Right cable, wrong end. The adjustment is done at the other end of the > cable > where it is clamped to the heater control panel. > > George > > > _________________________________________________________________ > Add photos to your e-mail with MSN 8. Get 2 months FREE*. > http://join.msn.com/?page=features/featuredemail > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.