Stan, there is no threaded adjuster at the tranny clutch arm. What are you referring to? Perhaps he left out the clutch release bearing that mounts inside the tranny bellhousing. Mark Stan Wilder wrote: > ........... > In the interim period: Check the threaded adjuster on your clutch > actuator arm, see if it is about the same as the tranny you installed (if > not try to match them). > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.