Volks, Trying to figure out why my two rear wheel bearings failed after 3000 miles.
Observations: 1. The large nuts that hold both bearings were tight .. no concerns of improper torque. 2. Both bearings seem to be greased with CV Molly ... is this an appropriate lube for wheel bearings? 3.. Both bearings were well lubed on the outside surface but did not have much lubrication on the inside/ backside. 4. The snap ring behind the outside bearing looked as if it hadn't been disturbed during the last bearing install. Any thoughts? Note .... front bearings were also replaced 3k miles ago .... they seem fine.
"people don't take trips, trips take people", John Steinbeck ... Travels with Charley Larry Chase Email: RoadGuy@RoadHaus.com Web: <file:///C:/Documents%20and%20Settings/RoadHaus/Application%20Data/Micro soft/Signatures/www.RoadHaus.com> www.RoadHaus.com What: North American Road Trip How: RoadHaus - 1990 VW Westfalia Syncro Today: Denver, CO |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.