I have a similar (possibly related?) problem with my left side outer CV joint. History: It was working fine until a few years ago when I replaced it just as a preventative measure. Since then, the outer CV on the driver's side will periodically start making noise. When I check it, it is DRY of grease. I repack it very full and bolt it back. 3000 to 5000 miles later, it is dry. I have no idea where the grease goes. The boot is fine. I have replaced it and the boot -- no help. I had a pro (Chirco's in Tucson) replace it and the boot -- no help. I am thinking of just getting a big syringe and needle and shooting some grease through the boot every 1000 miles or so. Bill in the Southwest ----- Original Message ----- From: "Larry Chase" <roadguy@ROADHAUS.COM> > > Trying to figure out why my two rear wheel bearings failed after 3000 > miles. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.