Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 25 Apr 2003 19:59:21 -0500
Reply-To:     Blake Thornton <blake@MATH.WUSTL.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Blake Thornton <blake@MATH.WUSTL.EDU>
Subject:      Re: Help, Clutch
Comments: To: Stan Wilder <wilden1@juno.com>
In-Reply-To:  <20030425.192541.1428.30.wilden1@juno.com>
Content-Type: TEXT/PLAIN; charset=US-ASCII

Stan,

Thanks for the reply and instructions. I figured something along these lines were the answer, but I had hoped that it would be some sort of adjustment (easy adjustment). Yuk. Alright, I'll be emailing the list as things move along.

Blake

On Fri, 25 Apr 2003, Stan Wilder wrote:

> First thing is to go to Bus Depot web site. > Get your credit card out. > Buy a clutch kit, front main seal and a flywheel O ring. They are about > as cheap as any source. > You'll have about five days after you order the parts to worry about > putting these parts in. > Drop the rear engine cross bar about 6 inches with long bolts. Buy six > Metric pressure plate bolts at ACE Hardware while you're there. > Dis connect your CV joints at the tranny. > Remove your starter. > Drop the front of the tranny on a floor jack. > Block the engine up. > Loosen the 4 bolts holding the tranny to the engine. > Disconnect the clutch slave and shift selector linkage, backup light > switch and ground cable. > With the engine to tranny bolts wiggle it forward until it is free and > can be dropped. > Take two day off and write back about installing the main seal, flywheel > O ring, Pilot Bearing. > Oh! By the way ................ I think there is a full write up in > Hayes, Bentley, Muir manuals. > Heck .......... you might even find it in the archives. > > Stan Wilder > > On Fri, 25 Apr 2003 18:59:15 -0500 Blake Thornton <blake@MATH.WUSTL.EDU> > writes: > > Well, I haven't attacked my clutch or transmission before, so I guess > > now > > is the time. My clutch is slipping (it won't stay in and it will > > alway > > stay in gear). I limped my van home, but I don't know where to > > start. > > Perhaps I can do an adjustment????? What do I need to do???? > > > > Help! Thanks! > > > > Blake > > St Louis > > 84 Westy > > > > > > ________________________________________________________________ > The best thing to hit the internet in years - Juno SpeedBand! > Surf the web up to FIVE TIMES FASTER! > Only $14.95/ month - visit www.juno.com to sign up today! >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.