Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 27 Apr 2003 22:32:59 -0400
Reply-To:     Dave Katsuki <dkatsuki@THEWORLD.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dave Katsuki <dkatsuki@THEWORLD.COM>
Subject:      Re: Bus Depot OXS Dilemma; Where Is the Truth?
Comments: To: THX0001@AOL.COM
In-Reply-To:  <1d1.83845c1.2bdc4825@aol.com>
Content-Type: text/plain; charset="us-ascii" ; format="flowed"

George,

I've been using the "generic" oxy sensors for 15 years or so, on a variety of cars. Never any problems (they always drive fine & pass inspection.) I've gotten them at the Bus Depot and from other vendors. If you buy the plug-compatible or OEM sensor, you will probably pay 3x the cost of the generic. Don't worry about it, is my experience.

Dave 90 Westy

At 4:37 PM -0400 4/26/03, George Goff wrote: >It came to light this morning that the OXS of my van needs replaced and a >trip tomorrow demands that it be done today. Since I am 1 of 2 Vanagon fools >who my VW parts guy ever sees, he, of course, does not have one on the shelf, >but I do have two other OXS's. One used (Bosch p/n 13931) and the other >brand new (Bosch p/n 13913). For the sake of brevity, I'll refer to them as >x31 and x13, respectively. > >The new x13 was purchased from the Bus Depot (BD) who offered it as an exact >equivalent of the x31 sans the connector. The used x31 has about 20 Kmi on >it and it is the exact Bosch replacement for the VW supplied part. > >I would like to install the new x13 which leads to my dilemma: Since I have >reason to doubt the veracity* of what comes from the Bus Depot, I hesitate to >use it. For one thing, the cold resistance's of the heaters of the x13 and >the x31 are different by a factor of 2. Also, I have no way of comparing the >active characteristics of this unknown, the x13, with the ideal. Above all >else, Bosch does not list the x13 as a substitute for the x31. > >Beyond relying on hearsay and anecdote, is there any authentication for the >use of the Bosch p/n 13913 OXS on a Vanagon 2.1L engine? > >*For those of you who bristle at my choice of words, look up their meaning >and go beyond the first definition which you may find before you are >compelled to defend the weak and beleaguered. Should you still feel cause, >contact me because I have ample documentation and hard goods as evidence to >the veracity of MY words. > >George


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.