Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 27 Apr 2003 13:36:42 -0700
Reply-To:     laurasdog@WEIRDSTUFFWEMAKE.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Delanty <laurasdog@WEIRDSTUFFWEMAKE.COM>
Subject:      Re: Help Wiring O2 Sensor
In-Reply-To:  <3EAC3CDC.8000403@charter.net>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 01:26 PM 4/27/2003, you wrote: >Do these Chrysler units fit the threads in the Vanagon catalytic converters?

Most O2 sensors seem to use the same 18mm spark plug threads. I've used those "spark plug anti-fouler" thingies you can buy at the FLAPS, and cut the female threaded part off and welded it to header tubes for an O2 ensor port... I think all the Bosch O2's I've seen have the 18mm thread.

Steve '86 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.