Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2003, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 4 May 2003 10:42:19 -0700
Reply-To:     TJ Hannink <tjhannink@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         TJ Hannink <tjhannink@YAHOO.COM>
Subject:      Re: Inner Dia. for long A/C hose - 87 Westy
Comments: To: Richard Golen <rgolen@UMASSD.EDU>
In-Reply-To:  <5.1.0.14.0.20030504131555.02357218@pop.umassd.edu>
Content-Type: text/plain; charset=us-ascii

--- Richard Golen <rgolen@UMASSD.EDU> wrote: > I need to find one of those metal splice connectors > to repair the leak. > Anyone know the inside diameter of the A/C hose? > Also, anyone know where I > can get one of those metal splice connectors?

If I remember correctly, the hoses running between the front and rear of the van are different I.D.'s. Any A/C shop should be able to get you the correct size splice, but I wouldn't recommend going that route. I had a splice in the hose that runs between the back of the compressor and the condensor and every summer, the hose clamps that secured it would loosen, I'd find a small puddle of orange refrigerant oil under the van and I would lose all my R-12 ($200.00 worth at the time).

I would replace both of the A/C lines (they are at least 15 years old if they have never been replaced before) that run from front to back on the van. One runs between the condensor and the receiver/dryer, while the other runs between the condensor and the compressor, so there is no need to remove any interior panels or cabinets to access them. The easiest (and cheapest) way is to remove them, bring them to a hydraulic hose shop and have them rebuilt using your original ends if necessary. Then re-install with new green o-rings and a new receiver/dryer, flush and refill the system with R-134a. Next time you service the evaporator/expansion valve, replace those o-rings.

Good luck,

===== TJ Hannink Goldibox - 1987 Vanagon Camper, Wolfsburg Edition Winter Park, Florida http://home.earthlink.net/~tjhannink/ http://groups.yahoo.com/group/wolfsburg_campers http://photos.yahoo.com/tjhannink [Vanagon] Album

__________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.