Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2003, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 11 May 2003 10:58:16 -0700
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: Solid lifter conversion.
Comments: To: wilden1@JUNO.COM
Content-Type: text/plain; charset=us-ascii

So, I guess when you get a lazy lifter on a flat 4 you just go ahead and rebuild the whole motor? Not me. And I guess on engines where the lifter adjustment shim is what rides on the cam you just put a new cam in along with all new shims every time the valves need adjusting? Not me.

Mark

Stan Wilder wrote: > .......... > Then there is the rules you're breaking ............... never run new > lifters on and old cam, never run a new cam with old lifters. >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.