Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2003, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 12 May 2003 13:37:29 -0700
Reply-To:     wilden1@JUNO.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1@JUNO.COM>
Subject:      Re: Check Compression:  Warm or cold engine?
Comments: To: mwstebbins@YAHOO.COM
Content-Type: text/plain; charset=us-ascii

There are up and down agreements on this. (I say up and down because I'm getting ready to duck when people start shooting me down on this procedure.) A warm compression check is most accurate ........... but NEVER REMOVE spark plugs from a hot Aluminum Head. So before you do a hot compression check, add thread anti seize to the plug threads, run the engine till it gets hot and then you can safely remove the spark plugs from a hot engine. The engine needs to be at full operating temp and it is a PITA working with it at full temp. Otherwise do it the country boy method and do it on a cold / moderately warm engine by just squirting a good shot of any weight motor oil into the cylinder and giving the engine a good spinning with the starter before you start your compression check. In either case the anti seize is a good idea since it helps seal the threads and you don't have to force the threaded end of the compression gauge to get a good seal. (There are pros and cons of Anti Seize on spark plug threads, a good squirt of Berryman B12 Carb cleaner will remove the anti seize from the threads after you've done your testing if you want to get rid of it.)

Stan Wilder

On Mon, 12 May 2003 11:09:24 -0700 Malcolm Stebbins <mwstebbins@YAHOO.COM> writes: > Should I have the engine warm or cold when I check the > compression?? > > My van seems to NOT be firing on the right (passenger) > bank of cylinders very well. I've changed spark plugs > and wires, the distributor is new as is the cap and > rotor and still it stumbles. It could be carburetion > (I have a carb) or it could be a compression problem. > Malcolm > > __________________________________ > Do you Yahoo!? > The New Yahoo! Search - Faster. Easier. Bingo. > http://search.yahoo.com > >

________________________________________________________________ The best thing to hit the internet in years - Juno SpeedBand! Surf the web up to FIVE TIMES FASTER! Only $14.95/ month - visit www.juno.com to sign up today!


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.