Date: Sun, 11 May 2003 19:22:26 -0700
Reply-To: wilden1@JUNO.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stan Wilder <wilden1@JUNO.COM>
Subject: Re: Air-cooled Oil Capacity - More info
Content-Type: text/plain; charset=us-ascii
The strainer doesn't hold any oil but the valve covers, lifters, sump
dump area, oil galleries, oil pump will hold some oil.
If you check your oil first thing in the morning before you start the
engine much of this oil is down in the pan.
After you start the engine some drop on the stick can be expected.
The total illusion is that there is way too much or way too little oil
because the oil pan is shaped like a baking sheet and is very shallow and
wide and long. Just a slight off level location will give some strange
readings.
I like to run my oil about 1/8" down on the dipstick below the max mark
after it's warmed up.
I also installed windage trays in the last four engines I built to keep
the oil in the pan.
A full discussion of windage trays is in the archives. They aren't a
necessity but nice to install if you ever have reason to split the case.
Stan Wilder
On Sun, 11 May 2003 20:04:52 -0400 "Justin M. Mayrand"
<jmayrand@acornworld.net> writes:
> Hi All,
>
> OK, here is some more info to add into the mix.
>
> The dipstick is approx. 54.7 CM long as measured from the bottom of
> the
> rubber "stopper". I *did* check it with the van level, but Stan gave
> me
> an idea - I also pull the strainer when I change to oil - is that
> taken
> into account for VW's 3.7 quart capacity? If not, that may be it.
>
> ...JMM
>
>
> On Saturday, May 10, 2003, at 12:08 AM, Stan Wilder wrote:
>
> > Yea! I have an idea.
> > Wait till tomorrow and with the van parked on a nice level spot,
> check
> > the oil.
> > You can loosen the strainer plate and let that extra 1/2 quart
> out.
> >
> > Stan Wilder
> >
> > On Fri, 9 May 2003 21:04:09 -0400 "Justin M. Mayrand"
> > <jmayrand@ACORNWORLD.NET> writes:
> >> Hi All,
> >>
> >> So, I just changed the oil on SuperVan, and it reminded me of a
> >> question.
> >>
> >> According to the manual, the 2.0 AFC hold 3.7 quarts of oil, yet
> >> when I
> >> change it, it takes 4.7 to reach the "full" mark on the
> dipstick.
> >> This
> >> is an AVP Longblock with factory oil cooler (no aux cooler) and
> >> correct
> >> filter. I believe that the stick is original, and does not look
> >> damaged
> >> or "tweaked" Any ideas? Thanks!
> >>
> >>
> >> Justin M. Mayrand
> >> 1980 Westy "SuperVan"
> >>
> >>
> >> --
> >> This message has been scanned for viruses and
> >> dangerous content by MailScanner, and is
> >> believed to be clean.
> >>
> >>
> >
> > ________________________________________________________________
> > The best thing to hit the internet in years - Juno SpeedBand!
> > Surf the web up to FIVE TIMES FASTER!
> > Only $14.95/ month - visit www.juno.com to sign up today!
> >
> > --
> > This message has been scanned for viruses and
> > dangerous content by MailScanner, and is
> > believed to be clean.
> >
> >
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
>
>
________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!
|