In a message dated 5/18/03 8:02:00 PM, blake@MATH.WUSTL.EDU writes: << The engine and the tranny are separated by about 1/8", but I can't seem to get the tranny off the studs coming from the engine on the bottom. What gives? Any ideas would be great. >> Blake, my man, the engine must be cocked. Try putting wedges in the parting line on top and lifting the crank pulley end of the engine. You might have to jack around with the alignment of the engine with the X-mmission a bit. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.