If it's down in the "hole from hell" at the outer end then I don't have much good advise for a stripped bolt.... Except to remove the bearing housing and pull the whole CV/axle assembly out where you can get vise grips on it. You'll probably have to remove the brake line and parking brake cable to get it out far enough. Good luck! Steve '86 Westy At 11:44 AM 5/18/2003, you wrote: >3 days and $250 in tools later I'm one bolt away from removing the >passenger side rear side. Let me re-phrase, this is the "proverbial" last >bolt!! The bolt is now somewhere between 1/4 and 6.5mm in size and closer >to sending me to the nut house! Any tricks short of C-4?? > >I'll probably end up buying new CVs but I will go thru the exercise at >least to save my pride. > >Thanks, > >Jorge and the Angry Bolt > >'85 Weekender |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.