Here are the two parts that will make removing the upper/lower ball joints and tie rods from the spindle. You still have to have you lower ball joints pressed out of the lower control arm. Tie rod end and Pitman rod puller P-36861 Opening size 1 1/16" AmPro Pitman arm puller T72069 opening size: 1 5/16"
I am telling you, these two tools will make removing those stubborn ball joints a breeze. It took me less than 30 minutes to have each side apart to replace the springs and no damage to the rubber boots... You do not need these brands, just match opening size.
Robert |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.