Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 27 May 2003 23:37:07 -0700
Reply-To:   Jere Hawn <jbrschawn@EARTHLINK.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Jere Hawn <jbrschawn@EARTHLINK.NET>
Subject:   Re: Brake problem
Comments:   To: gary hradek <hradek@yahoo.com>
In-Reply-To:   <20030527153938.85224.qmail@web41315.mail.yahoo.com>
Content-Type:   text/plain; charset="us-ascii"

Hi,

The pedal does not go all the way to the floor, well at I have not sat there long enough for it to get there after a four minutes I give up The emergency brake works fine. The van stops nicely. No fluid loss

The rear brakes... I fixed them in Mar. I though I was going though pads on the front too quickly so I checked the rears and I found that I had put one the springs on upside down so they were not adjusting, the spring coil was holding the adjusting nut in place. In short the drum look very nice and the shoes hardly have any signs of wear (as of Mar). I'll try adjusting them this week end.

Thanks Jere

-----Original Message----- From: gary hradek [mailto:hradek@yahoo.com] Sent: Tuesday, May 27, 2003 8:40 AM To: Vanagon Mailing List Cc: jbrschawn@EARTHLINK.NET Subject: Brake problem

Jere, "My pedal fades very very slowly" Does this mean the pedal goes to the floor? Does it stop the van? Does it feel soft? Does the emergency brake work well? "if your not loosing fluid anywhere" I am guessing that you did not take the drums off to look at the back brakes. It is a good idea to change your master cylinder from time to time but I would look at the rear wheel cyclinder next. If you have the cash buy a pair from bus depot and perhaps some new shoes for daddy since your are in there anyway. More than likely your rear brakes are out of adjustment. You might be lucky and can get by just by hand adjusting the shoes without pulling the drums but sooner or later you will need to pull the drums and fix the problem. Ignore the book about pulling the hubs. Just pull the drums and leave your big nuts alone. gary Date: Mon, 26 May 2003 21:36:31 -0700 From: Jere Hawn <jbrschawn@EARTHLINK.NET> Subject: Brake problem

Hi All,

Can anyone provide some assistance on this brake problem?

My pedal fades very very slowly. So I change the master cylinder and I've bled the system from the furthest brake forward no change. I spoke with a local car mechanic and he said that the cups in the cylinder have reverses themselves because I did not bench bleed the new master cylinder. He couldn't explain why there was no change from the original master cylinder. I checked for leaks: none.

__________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.