I am in the middle of converting my wasserboxer to a VW 1.8 I4. I have all the bits to do it and am about to install the trans with the diesel bellhousing. The bell housing has 2 alignment drilled dowels were the starter bolts pass through to thread into block. The problem is the block is not counterbored for these dowels. Can I grind them flush? There are two other dowels in the block that will fit in the trans for alignment. John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.