Date:         Fri, 6 Jun 2003 15:59:45 -0700
Reply-To:     marty <martysemail@WIDEOPENWEST.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         marty <martysemail@WIDEOPENWEST.COM>
Subject:      [OT-NVC] Need a chunk or rubber
Content-Type: text/plain; charset=us-ascii

Hi, I dislike asking this fine list of intelligent and resourceful
vanagon guru's a question as trivial as mine but I have no where else
to ask. I have an idea for a product and I need a piece of rubber
about 1/2 inch thick and 6 inches square to make a prototype. Anyone
have know where I can find one (or 3)?

Also, when I do procure said piece of rubber, I'll need to shape it
into the design I imagine. Any idea's how this would be easiest? I
figure I'll use an exact-o knife but there may be easier ways. 

Thanks for any help

-- 

marty
85 GL

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.