M9 nuts may be available at the Toyota dealer. They use them for some brake parts. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of John Reynolds Sent: Wednesday, June 11, 2003 7:45 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Nuts! I might be be able to make a few for you. This is too wierd though, I just was working out dimesions for M9-1.25 bolts today for a customer. I check at work tomorrow. - P-Mail me tomorrow night Typically, M9-1.25 is used as a repair screw for stripped out M8-1.25 holes, are you sure of the size? While 9mm is not a close match for any standard inch fastener, it still seems strange to use M9. John Reynolds Fastener Engineer
> Could everyone out there please look through their misc stuff and see if they have any 9mm x 1.25 nuts? >The van will run without them but it sure would be helpful if I could get at least 2 but preferrably 4. > >Thanks Mary |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.