Most likely the distributor drive gear is in the wrong position to line the dizzy up properly............nonethe less, just figure out where TDC # 1 is and go from there.........you can always pull the dizzy and move the gear on the bottom of the dizzy 180 to give you a different angle.........
Adam P 81 Westy "The Brick " 70 Single Cab "Whitey" 74 Beetle "Ol Yeller" 73 Transporter (STILL at paint shop) 1988 Vanagon Wolfsburg 1976 Transporter (New CA bus) 1974 412 "Goldmember" Used Vanagon Parts for sale (mostly aircooled) ----- Original Message ----- From: "Paul Wies" <Simplstupd@AOL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, June 08, 2003 11:46 AM Subject: 80-82 owners: distributor question
> My 82 has an 009 installed. I purchased a correct 205 for it and have 2 > questions: > > When you have the timing set at 7.5 BTDC, where is the rotor pointing? > > If you are looking down on the distributor, if the front of the Van would be > 12 o clock and the rear bumper would be 6 o'clock, where is the vac adv > sitting at and where is the condenser sitting? > > My guess is the PO installed the wrong engine tin, which won't allow me to > turn the distributor and seat it where it needs to be. > > Paul > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.