Date: Thu, 3 Jul 2003 14:42:22 -0400
Reply-To: Dennis Haynes <dhaynes@OPTONLINE.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Dennis Haynes <dhaynes@OPTONLINE.NET>
Subject: Re: R134a in 88 Weekender.
In-Reply-To: <20030702.213342.808.23.wilden1@juno.com>
Content-type: text/plain; charset=us-ascii
Read the directions. You need to turn the valve fully counter clockwise
to retract the piercing pin away from the can. Then you screw the valve
tap onto the can. Turning the valve clockwise will lower the pin into
the can piercing it effortlessly. Screw all the way down and ten open to
dispense into system. When empty, close the valve, disconnect the hose
form the suction port and then repeat above for the next can.
Dennis
-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf
Of Stan Wilder
Sent: Thursday, July 03, 2003 12:34 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: R134a in 88 Weekender.
Take those three empty cans and that Chinese can tapper back to Wal
Mart.
They'll give your money back.
I returned a pair of jeans after six months when the zipper just let go
along one side.
I often wear suspenders and the clasps never last, after about a month
they just give up.
I don't give up I go and get my money back.
The only way you're going to get better quality is to cost them money.
The coolest thing about Wal Mart is that you can get a refund faster
than
standing in line to buy something.
Stan Wilder
On Wed, 2 Jul 2003 21:13:15 -0500 VWNut Hawk <vwnut@HAWKCOMPUTING.COM>
writes:
> I went to walmart tonight and bout the little kit for 134a.
> It contained some couplers of different sizes, 3 cans of r134a a
> valve
> and a hose.
> I put the right coupler on the cold side connector of the air
> conditioning in the
> engine compartment. Puncturing the r134 can isn't easy. Once you
> start
> you must push very hard and twist the can on. Then the valve is
> made
> from
> plastic and the threads stripped. I got one can in the air
> conditioning.
> I had to go to an auto zone and get a metal valve and hose. These
> didn't strip the
> threads but it was very hard to puncture the R134a can and get it
> threaded onto the
> valve. I put it on the ground and pushed and got it on without
> loosing
> all the gas.
> Once I got three cans in the airconditioning it started working
> real
> well. I'll have to
> wait and see how long it keeps cooling this summer.
> Oh, the kit was $33.00 and the other good valve and hose was
> $13.00.
>
>
________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!