Date:         Tue, 1 Jul 2003 12:57:11 -0700
Reply-To:     Jeffrey Earl <jefferrata@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeffrey Earl <jefferrata@YAHOO.COM>
Subject:      Tail Lights/82 Vanagon
Comments: cc: thewitt60@HOTMAIL.COM
Content-Type: text/plain; charset=us-ascii

Tom wrote:
Pulled the tail light assembly apart
and =
discovered a real mess.
Water has been getting into this area on both sides of
the Van.
Think it will be necessary to fabricate a socket for
the tail lamp
bulb. =
Any experience on the list with this problem?
 Whats best solution?
How do you keep the water out?

I write:
I had a similar problem last year, such that a couple
of my bulbs quite working until I disassembled the
taillight and thoroughly cleaned the connections with
steel wool, then sprayed WD-40 over everything.

To prevent continued water infiltration, I installed a
section of polyethylene foam caulking material,
available at most any hardware store and intended for
filling gaps around door and window frames. I think it
was about 3/8" in diameter and I just stuffed about an
18" section into the upper perimeter of the back side
of the taillight assembly.

http://builders-hardware.aubuchonhardware.com/window_hardware_and_weather_stripping/weather_stripping/do_it_poly_foam_caulk_saver-288713.asp

Might also want to inspect/replace the rubber which is
designed to seal between the bulb socket assembly and
the lens portions of the light.

If you cannot clean-up or repair the socket assembly,
check eBay and buy the cheapest Vanagon taillight with
a cracked lens (assuming your isn't), but a good
socket assembly to swap in.


Jeffrey Earl
1983 diesel Westfalia "Vanasazi"



__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com