I've soldered mine and I'm only fair with an iron. But I suspect a whole lot of soldering will not be a good thing. Mike On 7/9/03 7:16 PM, "Matt Sutton" <msutts@EARTHLINK.NET> wrote: > Hi folks, > Anyone have some ideas about how to repair the printed circuit behind > the instrument panel? Mine is completely chewed up- first the oil pressure > system went nuts, now the tach doesn't work. Where the circuit meets the > multi connector is completely chewed up, copper tracks coming off the > plastic, etc. > I can solder well, but am concerned about weakening the plastic further. > I have the printed circuit from a different model, but it can't be used as a > whole (tach vs analog clock problem). > I'll be in the vicinity of a well stocked radio shack tomorrow...... > TIA > > -Matt Sutton > 88 GL (Manual) > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.