On Wed, 23 Jul 2003, Allan Kirk wrote: > Does anyone have words of wisdom about what would be likely to be the > cause of a "gusher" of a coolant leak on an old diesel vanagon? We're > not talking "drip, drip, drip"; we're talking a steady stream from > somewhere on the other side of the belly tin. Hard to say 'till you pull off the tin. Most of the stuff that can leak is on the top side of the engine, though, so if you're not seeing it coming out of the water pump or one of the hoses it may be a freeze plug. There are three of them underneath. Unless you've let water freeze in the engine a cracked block is probably the least likely possibility. I've only heard of two -- one was due to a thrown rod, and the other was due to vastly over-tightened head bolts. (Someone followed the tightening procedure for the stretch-type bolts on an engine with non-stretch bolts.) If you *have* blown a freeze plug make sure the cap on your expansion tank is venting properly. If it's plugged you can build up too much pressure in the cooling system and start blowing up all kinds of stuff.
David Brodbeck, N8SRE '82 Diesel Westfalia '94 Honda Civic Si |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.