In a message dated 7/22/2003 6:04:25 AM Pacific Daylight Time, Trvlr2001@AOL.COM writes: > Has anyone installed 16" wheels on their two wheel drive? > If so, what problems did you encounter, > and what tire size did you end up using? > I have a set of late model Mercedes wheels > I would like to use. Will these have to be machined? > Thanks for you help! I've installed 16" X 7" ET38 CLK alloys on a 2wd w/o any clearance problems. Most other late model MB wheels will have an offset not possible to fit w/o spacers. The cost of spacers, longer bolts/studs will likely make even bargain priced wheels expensive to install. BenT |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.