Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 23 Jul 2003 14:16:11 -0600
Reply-To:     Martin Jagersand <jag@CS.UALBERTA.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Martin Jagersand <jag@CS.UALBERTA.CA>
Subject:      Re: 82 VW Vanagon oil spray
Comments: To: jamesrphealey@yahoo.ca
In-Reply-To:  <20030723191533.9254.qmail@web12004.mail.yahoo.com> (message from
              james healey on Wed, 23 Jul 2003 15:15:33 -0400 (EDT))

Delivered-To: jag@cs.yale.edu Date: Wed, 23 Jul 2003 15:15:33 -0400 (EDT) From: james healey <jamesrphealey@yahoo.ca>

How critical is it that a 82 diesel engine have the oil squirter system. I have a very good 82 that requires a new engine. I have a factory rebuilt 1.5 that I am considering installing. Without the squirters, how much of a detriment will there be on a new engine?

Any advise and tips would be appreciated.

Driving style and condition of the rest of the drivetrain will affect the load and wear on the engine. A good condition drivetrain (e.g. exact wheel alignment, good bearings and CV's etc) with the 5.43 final drive ratio can do a top speed of about 65Mph / 100-110km/h (+-10% or so). At that road speed the engine is turning 4000rpm and developing nearly its rated 50HP (see graphs at www.cs.yale.edu/homes/jag/vw/engine/tdiswap/tdiswap.html)

However, if you drive just a little bit slower, 55Mph / 90km/h, the engine load decreases dramatically to about 25-30HP.

To cope with the sustained high loads at top speed VW designers added some improvements to the vanagon version of the VW engine, hence ideally it should be replaced with a vanagon block, or a TD block.

However, for the careful driver that is satisfied by a sustained highway speed of 55Mph / 90km/h, a standard automobile type (e.g. jetta, golf, rabbit) block will do. Using this block won't prevent you from occasionally fully loading the engine (while e.g. passing farm tractors and mopeds...;-), but it is advisible to avoid suatained full load for long periods.

Anoter solution which many vanagon owners have been pleased with is to swap the original 1.6l block for the more recent 1.9l NA, TD or TDI. There is much information on this swap in the Vanagon archives (gerry.vanagon.com) and I have a few pictures on: http://cs-www.cs.yale.edu/homes/jag/vw/engine/diesel1.9/

Best, Martin


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.