Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 24 Jul 2003 12:19:31 +0000
Reply-To:     maurio11@COMCAST.NET
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Maurio <maurio11@COMCAST.NET>
Subject:      Re: '80 Westy - Fuel Line Replacement Time
Comments: To: Jay L Snyder <Jay.L.Snyder@USA.DUPONT.COM>

If anyone could pass on detailed instructions (w/references to the Bentley) on exactly which hoses need replacing and how to do it. I'd appreciate it, I want to tackle this project soon... or should I just have my local guy do it when I bring her in for a check up? How much would something like this cost?

Thanks,

David /NJ 85 Wolfsburg Westy "Beatrix" > The hard plastic line is bullet-proof. No need to change it. The kit has > enough hose that allowed me to run from the plastic feed line to the engine > and from from the engine to the plastic line that goes back to the tank. > Perfect SS clamps. Love those kits for this kind of project. > > > Jay '85 Westy > > > > > Tom Young <tomyoung1@COMCAST.NET>@gerry.vanagon.com> on 07/23/2003 11:30:29 > PM > > Please respond to Tom Young <tomyoung1@COMCAST.NET> > > Sent by: Vanagon Mailing List <vanagon@gerry.vanagon.com> > > > To: vanagon@GERRY.VANAGON.COM > cc: > Subject: Re: '80 Westy - Fuel Line Replacement Time > > > This is one of the more confusing "maintenance" issues surrounding our > Vanagons. > > If you ordered the Part Number "Fuel1" kit from Van-Again then, as far as I > know, you've got enough 7mm line for the entire run from gas tank, through > the engine compartment and back to the gas tank. > > Inside the engine compartment itself something around 1 foot of 7mm line is > sufficient. Originally, the run from the front engine tin up to the gas > tank, on both sides, was a hard plastic line which fit *into* 7mm line at > the tin and at the gas tank. Since this "kit" is selling you 10ft of 7mm > rubber line I can only assume the idea is to eliminate the hard plastic > line > and replace it with 7mm rubber line. > > Maybe one of the vendors can tell us about the "missing" hard plastic line > and why it isn't offered. > > If you're in "maintenance" mode you might as well go ahead and replace the > fuel injector seals. 4 large and 4 small will do it. > --------------------------------------------------------------- > Tom Young '81 Vanagon > Lafayette, CA 94549 '82 Westfalia > --------------------------------------------------------------- > ----- Original Message ----- > From: "Jason Milam" <jason_milam@HOTMAIL.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Wednesday, July 23, 2003 4:08 PM > Subject: '80 Westy - Fuel Line Replacement Time > > > > > I'm in need of a little maintenence advice. I want to renew the fuel > lines > > on my > > '80 Westy. I ordered the kit from Van-Again which apparently has enough > line > > and clamps for the engine compartment. (Hasn't been delivered yet.) Does > it > > make sense to go ahead and renew the supply and return lines? Are these > > segments the same 7mm high-pressure line? Can anyone say how much > additional > > line I'd need to do the whole job bumper-to-bumper? What do I need for > the > > larger diameter segment from the filter to the pump? > > > > Does it make sense to go ahead and renew my fuel injector seals while I'm > at > > it. > > Van-Again offers two sizes. Do I need four of the large ones and four of > the > > small > > ones? > > > > > > This communication is for use by the intended recipient and contains > information that may be privileged, confidential or copyrighted under > applicable law. If you are not the intended recipient, you are hereby > formally notified that any use, copying or distribution of this e-mail, > in whole or in part, is strictly prohibited. Please notify the sender > by return e-mail and delete this e-mail from your system. Unless > explicitly and conspicuously designated as "E-Contract Intended", > this e-mail does not constitute a contract offer, a contract amendment, > or an acceptance of a contract offer. This e-mail does not constitute > a consent to the use of sender's contact information for direct marketing > purposes or for transfers of data to third parties. > > Francais Deutsch Italiano Espanol Portugues Japanese Chinese Korean > > http://www.DuPont.com/corp/email_disclaimer.html


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.