Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 28 Jul 2003 16:24:07 -0700
Reply-To:     Damon Campbell <damoncampbellvw@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Damon Campbell <damoncampbellvw@YAHOO.COM>
Subject:      Re: cv joint bolts?
Comments: To: Willolyn99@AOL.COM
In-Reply-To:  <5b.3be12958.2c56841d@aol.com>
Content-Type: text/plain; charset=us-ascii

Howdy, Bill,

I'm pretty conscious about dirt filling up heads of bolts and sharp allen wrenches. My buddy and i both looked at those bolts and came to the same shallow head conclusion (not the original bolts, though - ones that a sketchy shop in whitehorse, yukon, canada, used when my tranny was replaced 20k ago...). I even ground down a couple allen wrenches to get a super sharp bite to them and no dice. Clean and shallow.

This was my first work on CV joints (except for some 12-points on a karmann ghia), so i wasn't sure if this was standard for them.

Repeating an earlier question, is there a preferred bolt for CV joints, or will any ol' allen head do?

Thanks, -damon

--- Bill Marshall <Willolyn99@AOL.COM> wrote: > Hey Damon, > > First question is: did you clean out the bolt heads > before you removed them? > > The first time I took mine off, the allen wrench > spun around on the edge of > the head and I ended up using vice grips, etc. When > I looked at the bolts more > closely, I discovered they were full of grime, > grease, and dirt -- packed in > hard and mostly filling the head. They prevented > the allen wrench from fully > seating in the head. > > If you spray some solvent or WD-40 into the head and > then clean them out with > a nail or small screwdriver, you will be able to > seat your allen wrench > fully. I also give the allen wrench a few taps to > make sure. No need to swap > bolts, just keep them clean! > > Lastly, make sure your allen wrench (I use a > socket-type with a ratchet) is > in good condition, too. You may have damaged it > along with the bolts, take a > look at it. > > Best of luck, > > Bill Marshall > 85 GL Tiico "Pandora's Box" > Aurora, IL

===== '84 Westy (Sparky) '65 Kharma Ghia (Dharma)

__________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.