Agreed, if the blinking is steady and continuous without relay '43' it is likely the gauge. John did not give any detailed description of the blinking. I have seen blinking and needle weirdness caused by the sender wire being routed too close to the exhaust pipe near the thermostat housing on a 2.1. The insulation had melted through and whenever vibration caused the bare wire to touch the pipe the led would flash. If it touched solidly for long enough the temp needle would rise too but when you pulled over to the side of the road it would drop to normal and stop blinking. Drove my friend crazy. A few months ago I finally fixed an intermittent blinking on my sister's 82 diesel Vanagon. It was a long standing problem that was getting more frequent. She finally came to visit so I started fixing things on her van. The blinking problem drove me batty until I noticed that her alternator output voltage dropped completely at certain rpms. The led blinking seemed to be rpm related too and was worse when the headlights were on so I looked at grounds first. Finally I replaced the alternator and the blinking episodes ended. Too bad I couldn't look at the dash voltage with a scope as I bet it would have shown some drops that fooled the led circuit into thinking that the key had been turned of and back on. Mark David Beierl wrote: > > At 04:36 PM 7/31/2003, mark drillock wrote: > >The 82 does not have a relay '43' and the problem would have to be with > >the gauge, or with the temp sender, or with the wiring for one of them. > > Except that without the [newer-type] control relay, no likely combination > of events will result in the light blinking that does not also peg the > gauge. So the overwhelming likelihood is that it's the gauge -- especially > in humid weather. It *could* be an intermittent ground, but I doubt > it. Ah! -- it could be an intermittent problem with the +10v supply to the > gauge, or the gauge ground. I still bet it's the gauge. Mine right now > after a humid week blinks for quite a while until the heat from the working > element dries out the circuit board. > > david > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.