Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2003, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 29 Jul 2003 11:17:53 -0500
Reply-To:     Fredrich Hesterberg <FredsVW@WEBTV.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Fredrich Hesterberg <FredsVW@WEBTV.NET>
Subject:      Re: Alternator Deal"what is busdepot's record on this"
Comments: To: gary hradek <hradek@YAHOO.COM>
In-Reply-To:  gary hradek <hradek@YAHOO.COM>'s message of Tue, 29 Jul 2003
              08:46:31 -0700
Content-Type: Text/Plain; Charset=ISO-8859-1

Mr. Gary, One more thing just came to mind. My Campmobile has AC and I think any time AC is in machine large amp alternator is what it needs. I think that this is what parts book had in it. Low amp no AC Large amp AC Does this sound right ?

Good Morning, Fred

E-mail message

Fred,         I think the reason for going to a 90 amp alternator was that the highspeed fan, lights, blower and charging needs for a discharged battery(located a long way from the alternator) may be too close to maximum output for a 65 amp alternator.   Most of the time the output is below 10 amps so I would expect both alternators to run cool but perhaps the added winding may make the 90 amp run a bit hotter. This is assuming the wire guage is the same for the 90 amp and 65 amp.   The flow of electrons produce heat and the heat does damage to the insulation on the wires.   I would expect that on the whole the 90 amp runs hotter than the 65 amp but the 90 amp is less likely to fail when a heavy load is placed on it. I am just guessing on this.   What failed on my alternator was the rear bearing.   I am guessing that was from too tight of a belt. I intend to rebuilt this one for a spare to replace the two year old napa replacement when it becomes unstable. gary

Mr Gary, I believe all Westfalias have the 90 amp, which Is the case for me. And you are right when you say it may not be what you think when you buy. They could be anything in amperage. I did check this new one to be sure, and it is doing 92 amps. I also think maybe this. If a big amp alternator ( 90-- 125 ) will work less hard than smaller one. It will not run as much. Because it charges faster. I have two batteries, and need large output to get job done. So I think I am looking for used alternator to have rebuilt by local man who does nothig but rewind and redo these. I want maybe 125 amp. Faster battery recovery in two battery machine. But I do know what you say. Less heat small alternator. But if it work harder to do same as large one in short time, more heat. Yes? Good Morning, Fred


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.