Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (August 2003, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 1 Aug 2003 01:24:22 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Temp warning light blinking...
Comments: To: mark drillock <drillock@earthlink.net>
In-Reply-To:  <3F29B456.9390E468@earthlink.net>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 08:29 PM 7/31/2003, mark drillock wrote: >blinking. I have seen blinking and needle weirdness caused by the sender >wire being routed too close to the exhaust pipe near the thermostat >housing on a 2.1. The insulation had melted through and whenever >vibration caused the bare wire to touch the pipe the led would flash. If >it touched solidly for long enough the temp needle would rise too but >when you pulled over to the side of the road it would drop to normal and >stop blinking. Drove my friend crazy.

Right -- only takes a very short signal to trigger the blink which then continues for several seconds regardless.

>van. The blinking problem drove me batty until I noticed that her >alternator output voltage dropped completely at certain rpms. The led >blinking seemed to be rpm related too and was worse when the headlights >were on so I looked at grounds first. Finally I replaced the alternator >and the blinking episodes ended. Too bad I couldn't look at the dash >voltage with a scope as I bet it would have shown some drops that fooled >the led circuit into thinking that the key had been turned of and back >on.

It's very sensitive to input voltage -- I'm not even sure it will get all the way down to 9.5 without starting to blink. 9.499 maybe... <g>

The newer ones I've seen have tantalum timing caps instead of aluminum, has to help -- but I don't think they cleaned the boards enough to handle humidity gracefully, and of course as the cap gets leakier it takes less shunt resistance to upset everything.

d

-- David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage" '85 GL "Poor Relation"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.