I don't know if this will be useful to anyone but thought I'd put up a note about its tightening. My passenger door handle was loose and after removing most of the interior door panel I found that it can be easily tightened by moving the rubber door gasket/moulding aside in the jamb near the end of the handle, exposing a phillips screw, sliding a large phillips screw driver in there and tightening. I actually used a 3/8 drive ratchet with the phillips bit. Better leverage and got it tighter. I guess my "learning the hard way" curve penchant isn't done. Bob Stevens '87 Syncro Westy http://groups.msn.com/BobsPhotoShare |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.