Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2003, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 15 Aug 2003 21:40:53 -0700
Reply-To:     Damon Campbell <damoncampbellvw@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Damon Campbell <damoncampbellvw@YAHOO.COM>
Subject:      Bargain Basement Blowout!  Everything MUST GO!
Content-Type: text/plain; charset=us-ascii

This weekend only, make an offer on any or all of these parts (buyer pays actual shipping). Seller is in 755 Old Canyon Rd. Fremont, CA. 94536

All parts are coming from either an '87 syncro or an '84 westy. Anything not sold this weekend will be donated to the Kind people at buslab who will actually charge reasonable prices for this stuff...

<<<General Stuff>>> -Clutch, pressure plate, and throwout bearing - all in excellent condition. Clutch disk has about 75% life left (van had all highway miles). -Piston and Cylinder set. Look to be in good/excellent condition. -AMC heads, better than new (new SS valves installed) -OEM heads, used w/40K miles on them. Good condition -Coil out of an '87 Syncro -PS pump/bracketry out of '87 -AC pump/bracketry out of '87

<<<1.9 Stuff>>> -Longblock. Bottom end is very strong with 130k miles on it. Lots of life left in it. Heads could use new seals (probably black jobber at bottom of cylinder?) -Motor mounts. Used, but still nice and squishy. Replace your brittle ones with these for the price of shipping... -Coolant hoses - all the ones in the engine compartment. Still nice and compliant. They will get you a little further down the road.

<<<2.1 Stuff>>> -ECU. Worked when came out of van. -Idle stabilizer valve thingy -Idle stabilizer control unit -Distributor. Everything above the dizzy drive gear. -AFM and filter box. AFM has been opened up before (or at least had cap replaced with something home-made). Cheap! -Plastic air intake bellows thingy (i know *some* of these are broken out there!) -Coolant junction P/N 251 121 442 A -t-stat housing out of a syncro (oooh... high quality!) -engine mount bracket. The smaller one with all the rubber dampers on it. -Intake boot. Used, excellent condition -Intake boot. New. -Exhaust manifold (everything except muffler - J-pipe new)

<<<<end part list>>>>

Modus operandum is "quick and dirty". Make a an offer (and be willing to pay shipping charges) and i'll likely say "YES!", box it up, and mail it off with a place for you to mail your check. HONOR SYSTEM, people. Garage must get cleaned out this weekend.

Have fun!

===== '84 Westy (Sparky) '65 Kharma Ghia (Dharma)

__________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.