Fricking frackin van. My 86 2WD Westy has been running a little warm (have to turn the heater on sometimes) so I figure I'd better bleed it to be sure there's no air in it. So I park it up on the ramps, expansion cap off and it's up to temp, but I'm getting nothing from the thermostat bleed screw, some air from the rad, but I can tell if it's going in or coming out (coolant starts siphoning out of expansion tank?). Anyways, before getting any coolant out of the thermostat bleed screw or radiator bleed screw, my coolant boils over! What a mess! Thoughts? Bad thermostat (rad was warm, but no coolant from bleed screw). Did I screw something up in the procedure? Ack. Keith Adams calgary.ab.ca |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.