Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 23 Aug 2003 09:53:31 -0400
Reply-To:     Joe Glisson <drfactotum@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joe Glisson <drfactotum@YAHOO.COM>
Subject:      Re: start - won't sart - solution

Eric - I'm the guy who had the start won't start problem and fixed it by replacing the temp II sensor. This sensor is located in the thermostat housing and controls the amount of gas distributed by the injectors, varying when it is either hot or cold operating temp - I had plenty of spark but the plugs were being flooded by gas due to the bad sensor. Same thing happens with leaking injectors, or so I'm told. I don't think this temp II sensor will help at all it you have no spark. Good luck, Joe G.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.