Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 28 Aug 2003 13:50:38 -0700
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: 91 GL Running hot still...what next?
Content-Type: text/plain; charset=us-ascii

Rich had it right the first time but you have a point. The coolant won't circulate through the radiator unless it has someplace to go. Opening the bleed screw gives it a place to go, out the bleeder after the air escapes. With the bleeder closed it won't move through the radiator until the thermostat opens but that is too long to wait while bleeding since there may be a dangerous amount of air in the system.

At idle the cooling system relys on a siphon effect to help the waterpump move coolant through the radiator as the radiator is a high point. The siphon won't establish if there is too much air in the system so it is critical that the engine speed be increased and the air purged from the radiator. Once the air is out the pump will circulate coolant through the radiator just fine at idle, assuming that the thermostat has opened.

Mark

Andrew Fox wrote: > > Rich left out an important detail: > > The coolant won't reach the radiator and radiator bleed valve until the > t-stat opens. So you should not try to open the radiator bleed valve > until the t-stat opens. I usually run the van at 2000 rpm in the driveway > until the radiator fan comes on once which is a sure sign that t-stat has > opened and coolant is reaching the radiator, usually takes about 10-15 > minutes at 2000 rpm in the driveway to open the t-stat and reach normal > operating temperature. > > Andrew Fox > > > Follow a basic bleed procedure: cold engine, remove the coolant tank cap, > > start engine, turn the valve on the thermostat housing to the left, rev the > > engine up to about 2K and hold it there (might want an assistant for this > > part), open the bleeder valve on the radiator (you can remove it to get lots > > of air out faster but be ready to put it back on). > > > > If you don't have anything coming out of the radiator bleeder then you have > > a blockage. > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.