Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2003, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 22 Aug 2003 14:46:18 -0600
Reply-To:     don spence <dspence@OANET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         don spence <dspence@OANET.COM>
Subject:      Tapping oil drain plug
In-Reply-To:  <200308221949.h7MJnG128571@moe.oanet.com>
Content-Type: text/plain; charset=US-ASCII; format=flowed

This is a standard factory fitting on my Triumph TR4A. It works and is cheap and easy to replace.

On Friday, August 22, 2003, at 02:32 PM, Automatic digest processor wrote:

> Subject: Re: Tapping oil drain plug > > Hey Arthur, > > Your best bet is probably tap larger. Best solution > is a 3/8" pipe tap. It is a tapered tap. You can get > a plug from any hardware store. You will need a pipe > plug. Since it is a pipe plug, it tightens the > farther you screw it in. It is virtually impossible > to ever strip again.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.